TreeSense Wiki

Contents of the Sensor Kit – Sensor, electrode holder with two brass screws, and aluminum pin with cable ties Installation Kit – Drilling template with cable ties, 1.5 mm drill bit Required tools – Cordless drill, flathead screwdriver ⚠️ Test the data connection on the tree before installation. To do this, perform the sensor reset as described in Step 7. Installation 1. Select the desired position on the tree and place the drilling template in position. 2. Using […]

Would you like to perform a comprehensive analysis of the sensor data, combine it with other data sets, incorporate it into reports, or integrate it into your own system? If so, you can export the data from the cloud. What data is downloaded? Time, resistance, temperature, moisture index, temperature-compensated resistance, as well as information on which formula and tree species were used to calculate the moisture index […]

Package Contents: Sensor – FDR sensor with transmitter module and antenna; Required Tools – Shovel or earth auger, bucket, pole, water ⚠️ Test the data connection before installing it on the tree. To do this, perform the sensor reset as described in Step 9. Installation 1. Screw the antenna onto the transmitter unit. 2. Drill a hole with a diameter of about 12 cm to the desired depth […]

If your Pulse S is not sending data, there may be several reasons for this. Go through the following most common causes one by one. Possible causes: The Pulse S has never sent data: The reset was not performed or was performed incorrectly; No or insufficient LoRaWAN reception; The sensor is not registered on the LoRaWAN network. The Pulse S suddenly stops sending data […]

What's Included: Sensor Kit – Sensor with transmitter module and antenna, electrode holder with two brass screws, and aluminum pin with cable ties; Installation Kit – Drilling template with cable ties, 1.5 mm drill bit; Required Tools – Cordless drill, flathead screwdriver ⚠️ Test the data connection on the tree before installation. To do this, perform the sensor reset as described in Step 9. Installation 1. Screw the antenna onto the transmitter unit. 2. Select the desired […]

7-Step Guide Step 1: Under “Tree Registry,” go to the tree inventory or map view. Step 2: Click “Add Tree.” Step 3: Position the tree by dragging the map with your mouse or entering the tree’s coordinates. Step 4: Select an existing project or location. Alternatively, create a new project or […]